hello friends, im confused about how connect the L298N driver to my DC motor, i was looking for it on internet but theres a lot ways so i dont know whats the correct on, who knows the correct wiring?
thank you for reading
Edgar,
See the picture below:
This board can drive two DC motors. Yo need only one side (Motor A for example). Open the layout Map "Flight Controls" in the configurator. Assign the digital outputs "Trim_Motor_Up" and "Trim_Motor_Dn" 1. Connect the "Trim_Motor_Up" output to Input1 and "Trim_Motor_Dn" output - to the Input2 2. See below on this page how to connect: https://realsimcontrol.com/tips_met.html Use appropriate voltage source for your DC motor (12v or either from 5up to 35v depending on the motor) (no need to connect 5v input, but connect the GND of course) Vlad
