Hi Vlad,
I purchased the 3D printable plans from 737diy.com and have built the throttle quadrant for the 737-800. They've primarily designed it for MobiFlight but I think SimVim is a superior piece of software and I'd like to have everything running on SimVim. The unit is quite the unit and one of my favourite builds so far. It's heavy duty for sure.
The throttle quadrant has a few differences and I'm wondering if it is possible to set this up.
The trim wheel and speed brake both uses NEMA17 stepper motors for their respective motion. I can see the setup for DC motors but I don't have the modeling skill to modify the printable designs to attach those. The current setup of the throttle has limit switches for the trim needles and I can glue a couple in for the throttles and speed brake handle. I know you've convinced people to switch to DC motors before and I did in my original throttle quadrant. I don't think that's an option for me with the new one though.
Also, this model has a servo in the parking brake handle to push the parking brake to the off position so it stays in sync with the simulator. This is very similar to how your start switches work. Is there a setup option for that?
Thank you!